Our Trail Series 2 Rear Bumper with Smooth Motion Tire Carrier System
Specifications
· Constructed of high-grade precision cut 3/16" steel.
· Swing arm capable of holding up to a 40" tire
· Soft lock-out feature keeps your tire carrier arm in place when enabled
· 1" thick 3/4" recovery shackle mounts (optional screw pin shackles purchased separate)
· Weighs approx. 100lbs
· Includes license plate bracket and license plate light
· Includes rear back up camera mount for standard or 360 systems
· Includes rear back-up sensor holes* replacing a plastic OEM bumper will require that you purchase factory bezels see info below
· Works with OEM blind spot monitor systems and parking sensors (*see additional info below)
· Designed to utilize the stock receiver hitch
· Optional textured black powder coat.
· Hi-lift jack points.
· Designed and Made in the USA
Add-on Accessories
· Geri Can mount bracket,
· CB antenna mount,
· Horizontal hi-lift jack mount,
· Vertical hi-lift jack mount,
· Hi-lift/PullPal combo mount
**Sensor holes are included however they are not guaranteed to work. Depending on your take-off stock bumper you may need to purchase sensor parts from your local dealership: Sensor model numbers: 6MH85RX-FAB-BEZEL-PAR, 6MH84RX-FAB-BEZEL-PAR, 6MH83RX-FAB-BEZEL-PAR, 6MH82RX-FAB-BEZEL-PAR
* A narrow wheel with an extreme positive offset and a very wide tire may not work with the standard tire mount
We highly recommend customers wait until they have the product in hand to schedule installations.
This product contains chemicals known to the state of California to cause birth defects or other reproductive harm. For more information go to www.p65warnings.gov
